Page Contents

Dlock_01: no matching UKPRN found

This error triggers where the UKPRN in which the ILR submission is made does not match the UKPRN associated with the commitment in the apprenticeship service.

This error is normally triggered where providers have merged or a learner changes training providers. If the UKPRN number on the individualised learner record (ILR) submission is incorrect (provider merger) you will need to resubmit the data under the correct UKPRN Number.

If the UKPRN number in the ILR is correct, you will need to contact the employer to inform them that they need to ‘stop’ the offending commitment in the apprenticeship service. Key point: employer needs to stop the commitment from the correct date. In many cases this will be the same as the commitment start date, except in cases of mergers or changes in training provider.

You will need to ensure that the employer has the correct UKPRN for your organisation and that the new / replacement commitment in the apprenticeship service has the same UKPRN entered from both the employer and provider.

Dlock_02: no matching ULN number

When no matching record found in an employer digital account for the ULN then DLOCK_02 will be produced:

  1. You will need to confirm that the commitment has been approved (this will appear in the ‘Your Cohorts’ section if it is unconfirmed).
  2. Double check that the ULN entered in the commitment is correct and matches the ILR.
  3. If the ULN isn’t correct, and it’s before the start date, you should edit the ULN, in order to correct the error.
  4. If the ULN isn’t correct, and it’s after the start date, you should contact the Employer telling them to stop the commitment (back to the commitment start date).
  5. Raise a new commitment ensuring the correct ULN is entered.
  6. Both you and the employer will need to confirm the commitment.

Note: Please note this only applies to levy learners (ACT 1) if they are non-levy learners their ACT code must be set to code 2 which will clear the Dlock error without any corrections made on the DAS system.

Dlock_3: no matching standard code found

When no matching record found in an employer digital account for the standard code then DLOCK_03 will be produced:

  1. Check the standard description in the commitment matches the standard code in the ILR.
  2. If it doesn’t, and it’s before a successful data match, you can edit the standard description in the commitment to correct the error.